What are the protection methods of pneumatic lifting column? Next, the specialist of Longsheng Lifting Barrier Company, Shenyang Lifting Column, will introduce it to you. I hope our introduction can help you better.
Protection and Maintenance Measures of "Shenyang Lifting Column" Fully Active Lifting Column
1. When we use pneumatic lifting column, we can operate the lifting column individually or collectively through remote control.
When retracting the pillars, attention should be paid to at least parallel or slightly below the ground level to ensure accessibility for motor vehicles or snow removal equipment.
When the pneumatic lifting column is in operation, the speed of lifting and retrieving is allowed to be readjusted after the installation, not less than three seconds from the complete lifting to the complete retrieving and from the complete retrieving to the lifting.
In order to ensure that the lifting column operates in three perfect cycles within 60 seconds, it is necessary to ensure that the air storage device stores enough air.
The protection of pneumatic lifting column should be carried out at least half a year. During the protection, pumps or suction pumps should be used to clean up the drainage of buried pits, and lubricants should be injected into the main sliding track.
2. Clean and protect the exterior appearance of the lifting column every day, at least once a day. Even if the sand and gravel around the lifting column are cleaned up, it will prevent the sand and gravel from falling into the crack of the lifting column and leading to stuck.
And make sure that weekly sewage repairs and semi-annual cleaning and replacement of air filters are carried out.
Check the oil pot every three months. If you invent that the oil in the oil pot is running out, you need to increase it. In general, you only need to increase it once a year.
When the air pump is in operation, the moisture and impurities in the atmosphere will be brought into the storage tank. After a period of operation, sewage will occur in the storage tank. At this moment, the sewage valve should be opened for drainage.
In the operation of lifting column, to ensure the stability of voltage, it is recommended to install a voltage regulator.
When the operating voltage of the compressor is less than 220 volts, it is easy to cause excessive current. At this moment, the overload device protector will actively disconnect the circuit, so that the lifting column stops working. At this moment, it is necessary to press the button on the overload protector manually to restart the equipment.
3. If the lifting column is not used for a long time, it should be ensured that the lifting column is lifted several times a day. Through the air flow, the lubricant in the oil kettle can enter the lifting column to lubricate, and then the service life of the lifting column can be prolonged.
It should be noted that the temperature of the compressor on the lift column air pump will be higher after a period of operation. At this moment, do not touch directly. Especially in the era when the party needs to press the emergency relief valve on the back of the pump, the arm part should not directly touch the appearance of the lift column compressor, otherwise it is easy to cause skin burns